To: | Jim Henningsen <trguy75@gmail.com>, "triumphs@autox.team.net" <triumphs@autox.team.net> |
---|---|
Subject: | Re: [TR] O2 Sensor on TR6 |
From: | Stan Foster <stan@redtr6.com> |
Date: | Sat, 18 Jul 2020 18:58:04 +0000 |
Accept-language: | en-US |
Arc-authentication-results: | i=1; mx.microsoft.com 1; spf=pass smtp.mailfrom=redtr6.com; dmarc=pass action=none header.from=redtr6.com; d=dkc461.onmicrosoft.com; s=selector2-dkc461-onmicrosoft-com; h=From:Date:Subject:Message-ID:Content-Type:MIME-Version:X-MS-Exchange-SenderADCheck; bh=RjFpFWoEAIhmxxhVqRGGrcvzgnu0RUQ77+PlJJnPTb8=; b=0+Spp9JCGnfRfqaSwX7EaF/kEjNxQzK5p3p3p+uw9yeszw+01Pjr2KdlhpEpa8a84qE2NGk8uDaBj/+UuWQ6MWaaWZXfyF3dOlttz30F/iwyKl7a48+cMZcmglIlMEIQ0nRCRVqgf08ureOKFfZlDxCCnYLoTDIsULnodbx3sEI= |
Arc-message-signature: | i=1; a=rsa-sha256; c=relaxed/relaxed; d=microsoft.com; s=arcselector9901; h=From:Date:Subject:Message-ID:Content-Type:MIME-Version:X-MS-Exchange-SenderADCheck; bh=RjFpFWoEAIhmxxhVqRGGrcvzgnu0RUQ77+PlJJnPTb8=; b=JbTqMv+KlC8LAUJ0+JyWpJtRBRR/rZEJXJw1dVTu06HrsYzEdVdB1NUWYIdFm9kosdhF/VdHBZCPL4UYEKYbibS8gJg9vNCx/GOJ+pe+XDCqn7rtNF+xGyjWE7Z4i+ec0KSUzzEV7+SUWgc5PVA2rgczdnvtTbaRDlczBb9258HQNbW621wG/N5IufDOMwCH23lSpeuftrbl7kDbbZGwXXiZOjf8jKME3J0iBQxXqWGbWEMWaPg+kVZ9BrUnS+xrugRhhN2RA6VttkfCVAbDxMQ0MNfv2hHeJSFqmMGr15lbZs9pCA5Hhk2o8Y226egMfoRaU28Y8CctVxst3it+9g== |
Arc-seal: | i=1; a=rsa-sha256; s=arcselector9901; d=microsoft.com; cv=none; b=LEktyYkATD0rFGZEHbAq0okV05uT215MEpK6wTGJAkDd9xIyHfWVO/k2madbmXM5UUVDCvByhzCIk8HRMmUy6nt1HMUgZRoqRbruevCoOHEGr2t/wiwzb6IIR8GhHq/hcBpdXjXz6uU63UVmm2Q0xjJKD+tne0vPk5RlmpMb9aWivH+tU7OQnz04+9VUXxRrATT8FKcUNvHkFwgp6P+uXFZBtlrB2KWN62yS8bU5E1ZKBKh45EDa2qIhcwPI/YYI17mYQHPwDQIfbhiQIhp7cFQ9RrUPYOmyal6DOKbgpAnKzTjicw7cZwoBW4+BBET6NkiBQc8RGcQIWEP5uLHC+w== |
Delivered-to: | mharc@autox.team.net |
Delivered-to: | triumphs@autox.team.net |
References: | <00cb01d65c61$d6e05ee0$84a11ca0$@gmail.com> |
Thread-index: | AdZcYWzwxIm91AdiTEqYzyE97oKsxAA0x0Xw |
Thread-topic: | [TR] O2 Sensor on TR6 |
I have a wide band o2 sensor in my TR6 and it was helpful in setting up the DCOE carbs on my modified engine. The electronics, Bosch sensor and gauge were from Innovate and there are connections for hooking up to a laptop. The main issue I had was it is very hard to drive and watch the o2 sensor and while you can log the data coming off the sensor you don't get the other critical data such as rpm, speed, gear etc. I did try adding more gizmos to capture more data but failed to get them to work (gizmo would not trigger off my 123Ignition distributor). Stan -----Original Message----- From: Triumphs <triumphs-bounces@autox.team.net> On Behalf Of Jim Henningsen Sent: Friday, July 17, 2020 1:44 PM To: triumphs@autox.team.net Subject: [TR] O2 Sensor on TR6 Anyone have experience with adding O2 sensor on a TR6? I am working on installing street comp upgraded motor and have exhaust header going into 2 1/4 straight pipe with cherry bomb near rear. Will have Triple ZS carb setup. While everything is apart seems like a good time to install and O2 bung. Just curious if folks who have done this found it helpful in tuning carbs. Thanks Jim Henningsen Ocala, FL 61 TR3A 62 TR4 75 TR6 81 TR8 ** triumphs@autox.team.net ** Archive: http://www.team.net/pipermail/triumphs http://www.team.net/archive ** triumphs@autox.team.net ** Archive: http://www.team.net/pipermail/triumphs http://www.team.net/archive |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [TR] Starter, Geo Hahn |
---|---|
Next by Date: | Re: [TR] Triumphs Digest, Vol 13, Issue 187, Dan Tortorici |
Previous by Thread: | Re: [TR] O2 Sensor on TR6, jpaynepbr |
Next by Thread: | Re: [TR] Triumphs Digest, Vol 13, Issue 186, Dan Tortorici |
Indexes: | [Date] [Thread] [Top] [All Lists] |