The shoulder should be flush with the base of the piston. I insert it just a
little high then use a straightedge to bring down to flush. This way I know
they are both equally positioned.
Bill
TS30800L
Sent from my Handspring Treo
On Sep 14, 2018, at 11:08 PM, Jim Henningsen <trguy75@gmail.com> wrote:
When inserting a new needle into the damper piston bottom, does the needle
go all the way to "bottom out" in the hole, then secure with set screw. Or
does it go down before bottoming out so the wider shoulder of the needle is
flat with base of piston? SU H6 carb for TR3A.
Thanks,
Jim Henningsen
Ocala FL
** triumphs@autox.team.net **
Archive: http://www.team.net/pipermail/triumphs http://www.team.net/archive
** triumphs@autox.team.net **
Archive: http://www.team.net/pipermail/triumphs http://www.team.net/archive
|