Good tips and suggestions, Steve.
Todd, when I installed my Kirkey Vintage seat, as Steve suggests, I placed the
seat low and wore my helmet to take some measurements. I wanted to be below the
top of my roll bar and my bar fits under the factory hard top, so the height
limit was known and set.
I also modified the seat. I needed arm length but less leg length. When I
tilted or reclined the back to a comfortable arm length, the seat bottom
reduced leg extension needed for full clutch depression. I cut the seat to get
more recline without effecting the bottom and leg position. It was an easy
modification. I made a aluminum fill plates and had them welded in place. I
also moved the steering wheel closer to the dash to give more arm extension. I
spent a lot of time getting it all perfect for me.
There are optimal leg and arm positions. Bent arms, never fully extended and
when the clutch is fully depressed, your leg should not press on the seat
bottom and impede movement, but could lightly touch. I learned this in 1982
when I bought Bob Bondurant's first book of high performance driving.
The Kirkey seats come in different widths. Get one that fits relatively snug.
Measure yourself in the seated position. If you have to you can send it back
until you get the best fit.
I thought the Vintage seat looks best without the head rest, but then you have
to build a rest into your roll bar. Of course having the head rest extension
solves this issue.
I like that the Kirkey seats have a snap-in cover and inexpensive. I also
added a little lumbar padding under the cover.
Dave H.
> On August 13, 2018 at 4:02 PM Steven Belfer via Fot <fot at autox.team.net>
> wrote:
>
>
> Hi Todd,
>
> I fit a Kirkey upright seat in my TR3. I probably had it in and out of there
> 10 times and had the seat modified a bunch of times to get it right. I also
> had the cage re-worked to fit the seat and and give me protection on the
> left-side. I had the Kirkey seat-cover modified at an upholstery shop to fit
> the changed seat. I also added some custom foam lumbar-support pieces to the
> seat cover. The trick is to get the seat as low as possible in the car, then
> lean it back just right for your comfort. Test it while wearing your helmet
> and Hans device.
>
>
> ~STEVE
>
>
>
> > On Aug 13, 2018, at 6:05 AM, Todd Redmond via Fot <fot at autox.team.net>
> > wrote:
> >
> > Friends!
> >
> >
> > I'm looking for recommendations for a race seat for the TR3.
> > What are you using?
> >
> >
> > Thanks
> > Todd Redmond
> > 1958 TR3a
> > _______________________________________________
> > fot at autox.team.net
> >
> > http://www.fot-racing.com
> >
> > Donate: http://www.team.net/donate.html
> > Archive: http://www.team.net/pipermail/fot
> > Unsubscribe/Manage: http://autox.team.net/mailman/options/fot/steve at
> > artwithcars.com
> >
> >
>
> _______________________________________________
> fot at autox.team.net
>
> http://www.fot-racing.com
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/pipermail/fot
> Unsubscribe/Manage: http://autox.team.net/mailman/options/fot/dlhogye at
> comcast.net
>
>
|