And if my memory serves me correctly (which these days it often doesn?t!)
access to that plug and refilling the gearbox was an absolute s*d? That said,
my ?59 Frogeye and ?65 Midget didn?t have dipsticks. Yer just poked in yer
finger to check if it went into any oil.
Jonmac
From: Triumphs <triumphs-bounces at autox.team.net> On Behalf Of Paul Tegler
Sent: 30 August 2018 04:46
To: Don Hiscock <don.hiscock at gmail.com>; Randall <tr3driver at ca.rr.com>
Cc: triumphs at autox.team.net
Subject: Re: [TR] Looking for suggestions on tools to use to top off Triumph
transmissions
take a look at (forgive me) the MG Midget cover plug for the tranny dipstck
big round plug, VERY easy to install in a hole...sits behind the radio over the
tunnel
ptegler
On 8/29/2018 12:45 PM, Don Hiscock wrote:
The Le Mans TR3S and TRS cars did this into the 1960s, long after it had
stopped in production.
We almost did the dipstick top cover mod when we upgraded my TR3B to OD. Can?t
remember now why we didn?t....
FWIW, TR2 through early 3A had a dipstick for the gearbox. When I converted to
a TR6 box, I used the early top cover casting, so I could keep the dipstick.
The dipstick hole is roughly 1" diameter, so with care you can pour directly
into it. Lots less hassle than carrying a funnel and trying to keep it clean.
Of course, my car has the hole to access it, but it wouldn't be hard to add to
a later car. And the usual suspects sell a big rubber plug to fit it.
-- Randall
Hi All,
I hope you have had a great 2018 driving season so far. I was lucky enough to
travel from Cincinnati, Ohio to the 2018 Kas Kastner race in Beaver, Pa. myself
which all totaled was about a 700 mile round trip. I had a great time and the
car was problem free.
My question to the group is what types of tools to you use to top off your
transmission. Especially on the road? They all leak a bit and mine is no
different. What I am kind of concerned about is traveling on longer trips and
doing normal maintenance like checking the fluid level in the transmission. I
don?t have a access opening in my transmission tunnel right now but I plan to
address that issue and that kind of gets me to my second question. But first,
at the moment, to add transmission oil, I have to lift the entire car up on
jack stands, wait for the oil to center itself, then unscrew the fill plug with
a open end wrench. Not a solution for on the road? So, I was thinking about
cutting a hole big enough for a socket (6-point) or whatever will work on a ??
pipe plug, then use a 1 qt. oil can with a pump to top off the transmission. I
can fabricate a metal cover to plug the hole.
What have you guys done?
Thanks,
Dave Connitt
?67 TR4A IRS
Archive: http://www.team.net/archive
--
Paul Tegler
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/triumphs/attachments/20180830/fde061c1/attachment.html>
|