Good evening all
It is a lovely day in the neighborhood, ok not so much. The '3 is to going but
am closer. Just got back from a week working in Europe and first things first.
The intake manifold is coming off to have the gasket sealing applied.
Undoing all of the stud nuts on top, all good. All tight and came off clean.
Now to the two middle lower anchor ones. Hmmm, the one on the left was finger
tight?!?!?!? Crap. Ok now the left, the socket doesn't fit, okay larger
socket, it was easy as well. Oh crap, crap!! Off it came and looking at it,
split down the side ( image ) well that would not hold anything, now will it!!!
Okay, so I am replacing the nut?!?!?!? Looking for the collective wisdom
here....
* Do I replace the nut with another brass one from Moss etc? Another
supplier
* Do I replace the nut with a standard steel ( stainless one? )?
* Do I replace all of the nuts, now suspect of the strength of the rest of
the 60yr old nuts?
I am thinking it might be easier to simply replace all of the nuts with
stainless...
David
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/triumphs/attachments/20180818/57099108/attachment-0001.html>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: blowby2.png
Type: image/png
Size: 3496859 bytes
Desc: blowby2.png
URL:
<http://autox.team.net/pipermail/triumphs/attachments/20180818/57099108/attachment-0002.png>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: splitnut2.png
Type: image/png
Size: 1802994 bytes
Desc: splitnut2.png
URL:
<http://autox.team.net/pipermail/triumphs/attachments/20180818/57099108/attachment-0003.png>
|
