triumphs
[Top] [All Lists]

Re: [TR] Any suggestions ?

To: <triumphs@autox.team.net>
Subject: Re: [TR] Any suggestions ?
From: "Randall" <TR3driver@ca.rr.com>
Date: Sat, 31 Oct 2015 22:21:05 -0700
Delivered-to: mharc@autox.team.net
Delivered-to: triumphs@autox.team.net
Thread-index: AdEUT06ZQXp+PaNcRSeM0tdWWzjXggAFSJmw
> New TR3 rebuild with new clutch lines, master cylinder and 
> slave.  Silicone Dot-5 used throughout.  Clutch still "pumps up"

Do you mean it holds pressure all the time, or just that the pedal gets higher?

I'd try cracking the fitting loose at the MC outlet and see if that immediately 
changes the problem.  If it does, then it is a MC
problem and Tony is probably right about the pushrod being too long (or the 
stop being misadjusted).  (Another thing to check for
would be the pedal hanging up and not returning fully.)

If it is just the pedal height changing, though, without holding pressure in 
the system; then the slave is not returning fully.  The
spring is weak or the slave is binding.

When I installed a later TR6 gearbox, it moved the clutch slave rearward enough 
that the return spring was too long.  I had to
fabricate a tab to stretch the spring a bit farther to get the slave to return 
reliably under just spring force.

-- Randall  


** triumphs@autox.team.net **

Archive: http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>