Re: [TR] ignition lock barrel

[George Richardson <gpr@key-men.com>]

Slide the barrel into place with the key in it and rotate it back and 
forth to enter fully. the pin should engage the hole. Sometimes the pin 
may not retract on it's own so that it can go all the way in.
For those situations I tape it down and poke the tape out of the way 
with a fine awl once it's in position under the hole.
George Richardson
Key Men - Keys for Classics
www.key-men.com

On 7/10/2012 5:10 PM, Gary Nafziger wrote:
> Just received a new ignition switch for tr-3 and the barrel is separate from
> the switch. Just wondering how to install the barrel..................shove
> in?  shove in and turn?  poke something into little hole in the side of the
> switch which might release something to allow the barrel to slide in?  Just
> wondering.
>
> gary n.
>
> ** triumphs@autox.team.net **
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage: 
> http://autox.team.net/mailman/options/triumphs/gpr@key-men.com
** triumphs@autox.team.net **

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage: 
http://autox.team.net/mailman/options/triumphs/triumphs-archive@autox.team.net