triumphs
[Top] [All Lists]

Re: [TR] Headlight/Control Head questions - TR3A

To: <suhringtr36@comcast.net>,
Subject: Re: [TR] Headlight/Control Head questions - TR3A
From: "davewillner" <dwillner@ptd.net>
Date: Mon, 23 May 2011 08:20:36 -0400
I was thinking, the rim I bought (either TRF or Moss, not sure) has the 
lower tab riveted on towards the rear of the rim, I know Moss sells the 
"tab" separate. Maybe drilling out the old tab and riveting in more towards 
the front of the rim might compensate...then a little fine tuning with the 
adjuster screws might help...I'm going to try on a spare and to see and will 
keep you posted. Thanks Scott

Dave

----- Original Message ----- 
From: <suhringtr36@comcast.net>
To: "davewillner" <dwillner@ptd.net>
Cc: <triumphs@autox.team.net>
Sent: Sunday, May 22, 2011 9:56 PM
Subject: Re: [TR] Headlight/Control Head questions - TR3A


Dave:

I have run into the exact same problem with my headlight. I have tried 
everything and have not been able to get it to fit. I have an original 
bucket on the other side it it fits fine. So, I have located a spare 
original bucket and just got the adjuster screw replacements and the clip 
and will see if this resolves the issue. I did measure the diameter of the 
original bucket compared to the repro and the repro is a 1/16" wider, which 
could be the problem. We'll see.

Scott Suring
Mechanicsburg, PA
'70 TR6
'59 TR3A
----- Original Message -----
From: "davewillner" <dwillner@ptd.net>
To: triumphs@autox.team.net
Sent: Sunday, May 22, 2011 5:28:10 PM
Subject: [TR] Headlight/Control Head questions - TR3A



Just got my TR3 back from paint last week and have begun trying to remember 
where everything goes... Making pretty good progress, but have a few 
questions...

I have the original 2 adjuster buckets on my headlights but bought new inner 
retainers and the outer retainers as well as new rims, I'm using the PL700s 
also. When I snap the trim ring in place the top and sides fit nice, however 
there's maybe a 1/2" - 3/4" gap at the bottom, any ideas for a flush fit?

Also I purchased a repro control head from TRF and its for a non-adjustable 
wheel/column, I have a split column. When I got the car back the key (slot) 
in the stator that lines up with the control head is at about 11:00 and not 
straight up, so when I snug it down, the "off" blinker position is now at 
11:00.

The other problem, and this may be a bad part, is that there is probably a 
3/8" gap between the wheel and the control head that looks real bad, the 
plate on the control head is resting against the 3 stops on the wheel as its 
supposed and the set screws secure it fine...is that typical of these after 
markets?

Thanks

Dave Willner
Stroudsburg PA
59 TR3A
70 MGB
70 BSA 441 VS



triumphs@autox.team.net

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums



Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>