The original outlet fitting is soldered to the tank. It does have two
flats on it for a wrench but it is not obvious since it doesn't
protrude very far beyond the foam gasket. I would guess you broke the
solder joint. You must use two wrenches to re-install. I won't repeat
all of the previous posts but it can be re-soldered successfully. I
too would take this as an opportunity to install a shut-off in the
line. (been there, done that, etc.)
Allen
63 TR4
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|