> I am rebuilding the shifter lever controls in TR3 transmission.
> In order to remove the shifter forks I need to take out a retaining
> bolt.
> It's head is square about 8mm. Anyone know where to get
> a drive or socket that will fit it properly.
Any decent tool supply should be able to sell you a 5/16" 8-point socket.
I got mine at Sears, but you could mail-order from McMaster-Carr if you
wanted to.
P/N 5543A63
http://www.mcmaster.com/#drive-sockets/=6fmx6u
I also find it helps to use a T-bar with both hands to turn the socket, so
there is little or no side force applied to the set screw. The original TR3
ones weren't so fragile, but the later ones with the nylon insert snap
really easy.
-- Randall
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|