triumphs
[Top] [All Lists]

Re: [TR] Bummer Day

To: Carl TR <cfmtr3a@verizon.net>,<triumphs@autox.team.net>
Subject: Re: [TR] Bummer Day
From: Tony Drews <tony@tonydrews.com>
Date: Sun, 07 Feb 2010 22:00:54 -0600
Fairly common problem, unfortunately.  A helicoil or keensert would 
be acceptable.  The hole gets drilled and tapped oversize and a 
threaded insert is screwed in and locked into place, bringing the 
thread size back to normal.

- Tony Drews

At 06:27 PM 2/7/2010, Carl TR wrote:
>Getting the engine ready to drop on the chassis.   Ran into a problem...
>
>One of the bolt holes at the bottom of the front plate is 
>stripped.   It is one that is in the front sealing block - p/n 
>55810.   Part is no longer stocked at TRF and not referenced at Moss.
>
>I will look through my boxes of parts to see if I have a spare, but...
>
>Any suggestions?   Can it be filled and re-tapped?
>
>I do have a complete spare engine but I would rather not tear it 
>apart for this one part.
>
>thanks
>Carl
>--------------------------------------------------------------------------------
>Carl - Tampa
>1961 TR3A TS81802LO
>Body Off Restoration
>Completion Date: NATC 2010 (Jekyll Island, GA)
>http://mysite.verizon.net/cfmtr3a/
>(I need to update my pictures; 11/27/09

_______________________________________________

Support Team.Net  http://www.team.net/donate.html

Suggested annual donation  $11.47



Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs

http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>