Thanks to all who replied with information on the routing of the front
wiring harness across the radiator. I got a few good pictures from
Cosmo Kramer, George Haynes and Geo Hahn and a similar written
description from Jim Hassall. Looks like two P-clips were used on the
bolts securing the radiator duct along with a couple of the rubber ties
to hold the wires to the support brackets.
What's funny is that the upper and lower front valance panels were
replaced early in the car's life and there are several bendable tabs to
secure a wire harness that run below the grill opening. These appear to
have no purpose based on the input I've gotten and that the harness
doesn't reach well when installed using those tabs.
Thanks again everyone.
Ben - with a TR4A that's nearly finished.....
--
Ben Zwissler
bjzwissler@gmail.com
Columbus, IN
1966 Triumph TR4A
1973 MG Midget
1980 Triumph TR8
2007 Mazda RX8
2002 Yamaha FZ1
2003 Honda ST1300
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation $11.47
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|