i can still get to mine without removing it
Frank
To: Gary
Nafziger <nafzigerg@yahoo.com>; triumphs@autox.team.net
Sent: Wed, November
18, 2009 4:28:04 PM
Subject: Re: [TR] boot/bonett hinges
They are different,
the Drivers side hinge angles (a very small amount) to the right, the
passenger to the left.
On the same subject, I am replacing the passenger side
bonnet hinge, question ... must I remove the cubby box ... yes .... no ...
maybe ...
Thanks...
> Taking apart my tr-3 resulted in my throwing the 4
hinges together in a box. Now i'm having trouble telling them apart. I
noticed in the Moss catalogue that the boot and bonett hinges have differant
part numbers so i assume they're differant fitting. I find they look the same
as far as bold holes spacing. I did find that inside one hinge had the
numbers 4344 LH and 4348 RH. Another hinge had numbers 4346 RH and 4350 LH
with the remaining two hinges having no numbers anywhere. I can't figure out
why a hinge would have two numbers and another hinge have nothing at all.
>
>
I'm not sure how to tell the hinges apart, maybe just trial and error. If
anyone has experience or information it would help.
>
> thanks
>
> gary n.
-- "Thinking is the hardest work there is. That's why so few people undertake
it." - Henry Ford
Bill Pugh
1957 TR3
"Casper"
TS16765L
Wallace, CA
_______________________________________________
Support Team.Net
http://www.team.net/donate.html
This list supported in part by the Vintage
Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|