Hi Tom,
I wrote up an article on how I welded in my floors in my TR3 about 10
years ago. Hopefully, it can save you some trouble. Here is a link to the
website where I described it.
http://www.sctoa.org/floor.htm
Good luck. It is not as bad as it appears at first.
Bill in Tehachapi
Message: 2
Date: Thu, 23 Jul 2009 11:10:01 -0700 (PDT)
From: Tom Deutsch <tdskip@yahoo.com>
Subject: [TR] TR3 floor replacement questions -
To: triumphs@autox.team.net
Message-ID: <837558.51903.qm@web55603.mail.re4.yahoo.com>
Content-Type: text/plain; charset="us-ascii"
Hi folks. Quick question if I may on replacing the TR3 floors;
Does it matter is the engine is in/out of the car when replacing the
floorboards? She has slabs of sheet metal just resting in there now with a
couple of tack welds.
I have the front apron and cross-brace off as well - does that matter?
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|