Hello, All,
In replacing my rear axle pinion oil seal, I note that the flange itself
shows considerable wear. So much so that I doubt even a new seal will
actually
'seal' as it should. I also note that Moss sells a Speedi-Sleeve to remedy
this exact situation. It apparently is pressed over the worn area providing a
'new sealable surface' (their claim). Does anyone have experience with the
Speedi-Sleeve? Does it really work?
BTW, I'm a relatively new participant in the list as I'm just putting my 3A
back on the road after a 25+ year hiatus. What a tremendous resource it is!!
What you guys don't know about Triumphs isn't worth knowing....
Bill A.
**************A Good Credit Score is 700 or Above. See yours in just 2 easy
steps!
(http://pr.atwola.com/promoclk/100126575x1221421323x1201417385/aol?redir=http:%2F%2Fwww.freecreditreport.com%2Fpm%2Fdefault.aspx%3Fsc%3D668072%26hmpgID
%3D62%26bcd%3DAprilfooterNO62)
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|