I know this thread is getting a little stale but I'd add a couple
points:
If you forget to turn on the gas you will get some pretty bad and
ugly welds. It may be obvious but I've done it.
My experience with drilled out spot welds is this: If the old spot
weld hole is too small, the weld tended to fill the hole and not
penetrate the piece behind. Enlarging the hole about one drill size
and it worked just fine.
Allen
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|