Probably obvious but a caution just in case -- the early edition of
Haynes TR3/4 specifies a torque of 45#. As you would expect this is
way too low. The error was corrected in later editions.
On 8/9/08, Brian Jones <banc8004@comcast.net> wrote:
> ...several recommendations on torquing the head per Haynes (or other)
> instructions...
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|