I am in the process of rebuilding the master cylinder for the clutch in my
six. I am having a problem disassembling the piston in the MC. I have removed
the rubber boot, taken the circlip out and removed the push rod and washer. I
thought the piston would then come out but it won't. I can push the piston
against the spring into the bore and the spring will push it back up and just
stop where the circlip was. It sounds like metal on metal when it reaches the
top. There seems to be a lip in the cylinder holding the piston in. How do I
remove this. Should I try scraping it out with a knife while holding the
piston down with a screw driver? Any hints would be appreciated.
TIA,
Peter Schoppelry
'69 TR6
CC26418L
**************It's Tax Time! Get tips, forms, and advice on AOL Money &
Finance. (http://money.aol.com/tax?NCID=aolprf00030000000001)
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|