I have both; a long bubble on the car as well as a short bubble (finishes
about 6 inches from the back) that is probably going onto eBay soon, unless
there is some interest amongst the true enthusiasts.
--
Ian
62 TR4
-----Original Message-----
From: triumphs-bounces+lbc.resto=comcast.net@autox.team.net
[mailto:triumphs-bounces+lbc.resto=comcast.net@autox.team.net] On Behalf Of
pethier@comcast.net
Sent: Monday, November 05, 2007 11:57 AM
To: jar@aldermanroad.net; triumphs@autox.team.net
Cc: jar7u@hscmail.mcc.virginia.edu
Subject: Re: [TR] Pristine TR-4 hood availabe.
> I was going through some of my assortmented parts, and find that I have
> a pristine TR-4 hood. I'm not sure if it came off a -4 or 4A. Also,
> there were the "short" carb bulge hoods, and the "long" bulge hoods.
> Does anyone out there know the measurements for each?
No measurements should be needed, as the difference is quite obvious.
On the long-bubble hood (bonnet), the bubble reaches all the way to the aft
end of the hood.
In the more-rare early short-bubble hood, the bubble falls far short of the
rear of the hood.
I think all the TR4, TR4A, TR5, TR250 long-bubble hoods are the same, but
I'm no expert.
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
http://www.team.net/donate.html
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
http://www.team.net/donate.html
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
|