> I was going through some of my assortmented parts, and find that I have
> a pristine TR-4 hood. I'm not sure if it came off a -4 or 4A. Also,
> there were the "short" carb bulge hoods, and the "long" bulge hoods.
> Does anyone out there know the measurements for each?
No measurements should be needed, as the difference is quite obvious.
On the long-bubble hood (bonnet), the bubble reaches all the way to the aft end
of the hood.
In the more-rare early short-bubble hood, the bubble falls far short of the
rear of the hood.
I think all the TR4, TR4A, TR5, TR250 long-bubble hoods are the same, but I'm
no expert.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
http://www.team.net/donate.html
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
|