Brian,
I went into my local NAPA store and ordered the allen wrench. They didnt have
one in stock but it was in the next morning. I would send you the one I have to
use but for the price of postage both ways you can probably buy your own and
have it sooner.
Aaron
Aaron Cropley
71 TR6 (Throttle Body Injection!)
http://www.triumphowners.com/108
Topsham, Maine
-----Original Message-----
From: bahodge80@yahoo.com
To: triumphs@autox.team.net
Sent: Thu, 28 Dec 2006 3:22 PM
Subject: [TR] Tipping Valve
Hi all,
I've never been on the list and I am not sure just how this works so I'm
just going to jump right to the point.
I own a TR 250, I got a brake master cylinder repair kit from Moss.
I have removed the master cylinder from the car.
In the workshop manual it says push the master cylinder secondary
plunger
in slightly and take out the tipping valve.
My problem is that it looks like I need a giant Allen wrench to take out the
tipping valve.
I tried use a bolt head of the proper diameter to remove it but it seems
like its too hard, and I dont want to break anything.
How do I get it out?
Tia
Brian Hodge
TR250 CD2558LO
Tired of spam? Yahoo! Mail has the best spam protection around
________________________________________________________________________
Check out the new AOL. Most comprehensive set of free safety and security
tools, free access to millions of high-quality videos from across the web, free
AOL Mail and more.
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|