> Yesterday tried and failed to fit a new rigid fuel pipe from tap to
> tank. Is there some black art to this job?, because it has to pass
> through the chassis, does this require to do all the bending in-situ,
> because if you pre shape it then it becomes impossible to pass it
> through the two small holes in the chassis leg.
As I recall, there is a union in the tube under the car, which allows the
two sections to be slid into place with only some slight bending. This is
supposed to be steel "Bundy" tubing, which should take a fair amount of
bending before it cracks.
Randall
CONFIDENTIALITY. This electronic mail and any files transmitted with it may
contain information proprietary to NavCom Technology, Inc., or one of its
affiliates, and are intended solely for the use of the individual or entity to
whom they are addressed, shall be maintained in confidence and not disclosed to
third parties without the written consent of the sender. If you are not the
intended recipient or the person responsible for delivering the electronic mail
to the intended recipient, be advised that you have received this electronic
mail in error and that any use, dissemination, forwarding, printing, or copying
of this electronic mail is strictly prohibited. If you have received this
electronic mail in error, please immediately notify the sender by return mail.
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|