Fitting up my new loom to RHD TR2, all going quite well, as always
there are a few Q's, I appear to have 3 wires on the branch loom to
the wiper motor, diagram shows 2, I have green, green/black and black
(earth), traced the other end of the green to an extra wire near the
group of greens at the fuse box, is this just a different way of
including the motor onto the fuse circut?. The other issue I have I
cannot figure out the route of the branch wiring to the wiper motor,
in all my books it does not show a clear path for this part of the
loom, an as it stands it is too short from where it exits the
firewall with the main loom to reach the wiper motor, my early car
has the motor on the R/side and being RHD I also have the
brake/clutch master cylinder to get around. One last one the control
box shows tow earth wires going to the final connector, there is only
1 coming off the loom, and another with a ring connector on it, where
does this fit?
Thanks
John
--
John Gillis
1954 Triumph TR2
1991 Kawasaki W650
Dublin
IRELAND
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|