You know Marty, you're a real bundle of joy. I'll bet in the old days you were
the guy who walked about with a bell calling "Bring out your dead!".... Just
joking. :^)
Seriously, I do have a slightly modified cam on the engine. I'm damned if I
remember the grind though. I had it done back in 1991 by a now defunct
rebuilder. Then the engine sat for years awaiting the rest of the frame-off.
Notes from that time are scarce. It's beginning to look like I too should
check out Horrible Fright and buy a half-decent dial guage kit and start
testing things.
Are there any recommendations from the list of versatile, but not too
expensive dial guage kits?
Cheers,
Mark
________________________________
From: owner-triumphs@autox.team.net on behalf of Martin Sukey
Sent: Wed 04/10/2006 8:19 PM
To: Mark Hooper; triumphs@autox.team.net
Subject: RE: [TR] Exhaust back-pressure - getting detailed in a general sort
of way
Mark, a couple more thoughts. Is this a stock cam or an upgraded cam? If
upgraded, did the shop have the specs to degree it in too? If not he would
have probably used the factory timing marks and the settings might not be
the same as the replacement cam. Another thought is your camshaft is shot,
as a couple of the cam lobes are worn down. This would have nothing to do
with the repair but would have been gradual.
Marty
-----Original Message-----
From: owner-triumphs@autox.team.net [mailto:owner-triumphs@autox.team.net]
On Behalf Of Mark Hooper
Sent: Tuesday, October 03, 2006 11:53 PM
To: Martin Sukey; triumphs@autox.team.net
Subject: RE: [TR] Exhaust back-pressure - getting detailed in a general sort
of way
In the words of Philip Fry, "Oh Crud!"
You can imagine I will have to do some testing, but I can only hope that
they
just slapped on the chain and didn't adjust the timing. That would put
things
way off without requiring me to tear apart the front end (or face another
warranty battle). It could well be you're all right since the low end torque
seems to be quite poor off the start whereas before the fix she had a very
good pull. Now to hope that it's adjustment, not wrong tooth/chain
placement.
Mark
________________________________
From: owner-triumphs@autox.team.net on behalf of Martin Sukey
Sent: Tue 03/10/2006 9:13 PM
To: Mark Hooper; triumphs@autox.team.net
Subject: RE: [TR] Exhaust back-pressure - getting detailed in a general sort
of way
I vote with Randall. It sounds like the cam timing is a tooth or so
different than what it was before.
Marty
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|