Jeff, The two pieces sort of snap together but they don't snap into the
console, they just protrude through it. All TR4A's have (or should have) a
dash support. The boot with the leather was a replacement for the all rubber
one on a 4A and is the same as that used on a TR6. In fact the rubber under
the leather is the same as the all rubber for the 4A.
The lower boot needs to be properly oriented in the transmission cover and
then the upper boot snapped into the lower one.
JVV
----- Original Message -----
From: "Jeff Porter" <jeffyporter@hotmail.com>
To: <Triumphs@autox.team.net>
Sent: Monday, May 30, 2005 3:14 PM
Subject: TR4A Shift Boot
> I bought an upper and lower shift boot that is listed for my 67 TR4A. The
> upper boot doesn't fit in the hole correctly. It looks to me that this
setup
> is for a TR4A that doesn't have the padded dash support. I thought all
> TR4A's had a center dash support.
> There is listed in the Moss catalog a GAITER, leather, w/upper boot
> (680-745).
> Has anyone used this on there TR4A? Does it just pop into the pop into
the
> dash support hole?
>
> Jeff Porter
> 67 TR4A with no shift boot.
|