In a message dated 08/26/2004 1:38:19 PM Eastern Daylight Time,
105671.471@compuserve.com writes:
> Keeping the bullet connectors on the end of the wire is not the problem,
> the real problem is maintaining a good electrical connection between the
> bullet and the connector into which it is inserted
I wire brushed the ends then used some dielectric grease on all
connectors/connections after re-soldering. The grease aided in the insertion.
Best Regards,
Ed (58 TR3A)
Check out the new British Cars Forum:
http://www.team.net/the-local/tiki-view_forum.php?forumId=8
|