At 10:37 PM 8/2/2004, you wrote:
>Several years ago I installed the "new improved type" seal sold by
>Restorations. It has always leaked however not as bad as the old scroll
>type. I read where they later said that the instructions for turning the
>crank were wrong and the it should be cut down less than what they
>instructed.
>Well the leak has increased recently.
>Anyone know if they have a "improved, new improved type seal for those of
us
>who followed the instructions and turned too much off the crank?
>
>Bob Nogueira
Bob
Some crankshaft grinding companies offer selective electroplating
followed by a regrind to the correct size. I have never had it done
or have any idea of cost, but it is an option.
Peter Murray
*************** INTERNET E-MAIL CONFIDENTIALITY FOOTER ************
This message may contain confidential information and must not be copied,
disclosed or used by anybody other than the intended recipient.
If you have received this message in error, please notify us by e-mail
(postmaster@mwkl.co.uk) and then delete the email and any copies of it.
Thank you for your assistance.
M. W. Kellogg Limited
Kellogg Tower, Greenford Road, Greenford, Middlesex. UB6 0JA, U.K.
Telephone: +44 (0)20 8872 7000. Fax: +44 (0)20 8872 7272.
Registered Office: as above
Registered in England & Wales No. 909986
Check out the new British Cars Forum:
http://www.team.net/the-local/tiki-view_forum.php?forumId=8
|