Hi,
When tracing a leak from my brake reservoir I noticed the fitting between
the inner and outer can was loose (TR3A link to pic below). I took it apart
to clean it and found the rubber seal between the cans was badly
deteriorated.
I can probably make a new gasket out of blank rubber but I'll probably get a
better seal with some sort of gasket-in-a-tube, I'm running DOT5 silicone
fluid so would a silicone based compound be safe?
http://home.cogeco.ca/~amcewen2/explode3.jpg
<http://home.cogeco.ca/~amcewen2/explode3.jpg>
Many thanks
Art
Art.mcewen@moh.gov.on.ca <mailto:Art.mcewen@moh.gov.on.ca>
Art McEwen
Sr. Database Administrator,
Technology Management Br.,
Ontario Ministry of Health and Long-term Care
art.mcewen@moh.gov.on.ca
Ph (613) 548-6622
FX (613)548-6693
Pgr (613)536-7666
text page 4167195768@e.pagenet.ca
"Do the best job you can in 15 minutes, and then move on. Doing a partial
job, will often suffice."
- Stress Tip MOHLTC Newsletter
|
