Hi List
This may seem as some stupid questions, but I still hope for your
opinion....
Q1: During installation of my rebuilt TR3 (low port) head, I read in the
Service Instruction Manual that I should omit the washers under the head
nuts. Why are they then listed in the partlist?? If I should use
washers, do they need to be hardend og could I use e.g stailess steel?
Q2: When I bought the basket case of a car, a set of Rocker Spacer Set was
included. These equally sized spacers are supposed to replace the
springs, but the one in the midle does not fill up the gap - thus
resulting in wobeling rocker arm. Anyone used these and do I miss
something?
Q3: Could I use std. split pins to fix the end caps on the rocker shaft?
TIA
Terje Kolbeinsen
Norway
TS 15715 frame up rebuild
|