To: | "Triumph Mailing List" <triumphs@autox.team.net> |
---|---|
Subject: | RE: Tie-rod end tightness |
From: | "Randall Young" <Ryoung@navcomtech.com> |
Date: | Sat, 10 Apr 2004 19:09:31 -0700 |
> When installing new tie-rod ends today, I found I could tighten three of > the four to about 25 lb-ft but the fourth [an inner] would not because > the shaft would turn. Use a pry-bar to force the tie-rod end firmly into the center link while tightening the nut. If that won't give you enough friction to turn the nut on the threads, then I would suspect something is wrong, like the taper is not formed right or the threads are damaged. Randall |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Tie-rod end tightness, Glenn Coughenour |
---|---|
Next by Date: | Re: Tie-rod end tightness, David Robertson |
Previous by Thread: | Tie-rod end tightness, Glenn Coughenour |
Next by Thread: | Re: Tie-rod end tightness, David Robertson |
Indexes: | [Date] [Thread] [Top] [All Lists] |