> Any other recommended source, other than MOSS or
> VB? Sources
> for good used assemlies? Is it better to buy (if available) a
> complete rebuilt
> assemly from an independant, such as
> http://www.shastacounty.com/rockerarm/#index,
Send your assembly in to Rocker Arm Specialists (the link above). That's
where I sent mine, and I'm very pleased with the results. Looked absolutely
brand new ... I'm still not convinced they didn't replace every single part
... but the cost was less than that of the shaft & bushings from Moss or
TRF. At the very least, they also replaced several locknuts (maybe all of
them), and refaced the rockers and the pushrod pivots.
Randall
|