In an attempt to start my newly rebuilt TR6 motor I pre-primed the motor by
spinning the oil pump with a cordless drill and a 6" X 1/2" bolt. All worked
except I could not see a reading on the oil pressure gauge. I removed the oil
pressure line at the block spun it again and no oil came out of the fitting. I
was under the impression I would see oil coming out of the rockers too. I did
change the pressure relief piston and spring I didn't start the motor, I
wanted to be sure .Any advice?
Cliff
73 TR6
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|