> Having finally threaded the wires down the stator tube, after many days
> of headscratching and sore fingers, I find that the short tube attached
> to the control head will not slide down the stator...I have it in about
> an inch.I have lined up the punched line with the slot etc.. I have
> tried tapping it with a block of wood and hammer etc, but it does not
> seem to want to go in..
>
> Is there anything here which would cause an obstruction, or is there a
> trick to it?
No trick, it should just slide easily over the stator tube. Er, you _are_
putting the control head tube _over_ the stator tube, aren't you?
Is it possible the wires (or the jacket over the wires) are bunched up
inside? I find it works best to tug on the wires to pull the control head
into place.
Randall
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|