Thinking about replacing the small end bushes on my TR2 engine
rebuild. I have new old stock BHB 20thou+ pistons to fit. There is a
small amount of lateral play when the gudgen pin (wrist pin) is
fitted to the conrod,and I guess there should be none?. Are these
bushes a DIY job, I presume I have to ream them in place to 7/8", do
they come with the oil feed hole?, any advise would be welcome.
John
--
John Gillis
1954 TR2 TS3618. October 1954 (ground up)
Trinity College
Dublin,
IRELAND.
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|