Dave:
Any time I run into DPO brazing, I reach for my Dremel grinder and the small
cutting discs. I try to cut/grind through the brazing by following an edge
line of one of the parts I'm trying to separate. If this doesn't completely
release the brazed parts, it should weaken the joint enough that minimal efort
with a hammer and chisel will finish the job easily and without collateral
damage.
--
Mark Macy
Sporty Car Garage, Inc.
Springfield, OH
www.sportycargarage.com
57 TR3 TS16942LO
57 TR3 TS17734L
58 TR3A TS?????L (Parts Car)
59 TR3A TS53427L (Parts Car)
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|