On Sat, 13 Apr 2002, Hugh Fader wrote:
> "Tuning Standard Triumphs" by Vizard (which I downloaded from somewhere some
> time) gives .0012 - .0020 as the clearance for the mains. Does this sound
> right?
Yes. If you are doing a custom grind and polish, you would likely aim for
the .0020 range, as the motor will turn more "freely". But anything in
that range of .0012 and .0020 is fine.
Also note that the oil pressure will likely be a tad lower with the .002
clearance number. But not significantly lower (figure a couple of pounds
at idle.)
> >
> > I want to Plastigage my main and con rod bearings. Bentley
> > gives .001 -
> > .0027 as the range for con rods. For the mains, I can't find
> > any trustworthy
> > information in Haynes or Bentley. There is no clearance spec
> > that I can find
Have fun!
rml
------------------------------------------------------------------------------
Bob Lang Room N42-140Q | This space for rent
Consultant MIT unix-vms-help |
Voice:617-253-7438 FAX: 617-258-9535 |
------------------------------------------------------------------------------
/// triumphs@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe triumphs
///
/// or try http://www.team.net/cgi-bin/majorcool
|