Hi List
The tank came back fron the Gas Tank Renu process yesterday. It has a new
permanent coating on both inside and outside.
The drain? plug on the bottom was left loose. What do I use to seal it
when tightening? Something in a tube or tape.
Also the vent on top was loose. What I mean is the tube that follows along
the outside of the tank. I'm thinking that should also be very tight.
The hole where the fuel line goes- is that only a compression fitting or
does that require something also?
I'm hoping that the fuel line from tank to front of car will be good - or
is that not right?
All for now
Roger Ryan
62 TR4
_______________________________________________________
Send a cool gift with your E-Card
http://www.bluemountain.com/giftcenter/
/// triumphs@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe triumphs
///
|