Scott :
The brake backing plates can be removed without the dreaded hub puller.
Just turn the locktabs and undo the 6 (4 on early cars) bolts that run from
the axle side through the backing plate and into the bearing housing, then
slide the hub, shaft and bearing assembly out as a unit. There may be shims
between the backing plate and the axle housing, be sure to put them back
when reassembling. They set the bearing clearance.
Randall
suhring wrote :
>
> Is there any way to remove the rear brake backing plate
> without having to remove the hub?
/// triumphs@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe triumphs
///
|