Jim,
I believe I have plenty, however they are in the garage attic. Will have to go
and sort etc. I wont be able to check for roundness until then. I am going out
of
town tomorrow until Tuesday so I wont know until the weekend after this. If it
is
not too cold when I return, I may have time to journey into the garage on return
Tuesday. I will save your email post and give you and update when I return.
Bob Labuz
1958 TR3A
1974 T140V
a Wallace wrote:
> Hi Folks,
> I have just taken apart the last of my front suspension and three out of
> four of the lower control arms' inner end holes are oval instead of round,
> as the nylon bushes wore through and there was metal-metal wear. I did put
> out a request for suggestions and was advised that while it may be possible
> to fill in with weld and re-bore, a lot of time and work could be saved if
> I could find replacements. The main issue would be getting the new hole in
> just the right place. BUT, they aren't available from the usual suspects.
> So this is my plea: can anyone supply any of these? (My right rear arm is
> the one that's OK.) If you can, please get in touch and let me know what
> you'd like for them....
> Many thanks in advance,
> Jim
///
/// triumphs@autox.team.net mailing list
///
|