To: | "Brian Sanborn" <sanborn@net1plus.com>, <Triumphs@autox.team.net> |
---|---|
Subject: | Re: TR2 crankshaft bearings, cylinder sleeves, etc. (long) |
From: | "Bob Kramer" <rgk@flash.net> |
Date: | Sat, 10 Feb 2001 10:54:16 -0600 |
Cc: | "Randall Young" <ryoung@NAVCOMTECH.COM> |
References: | <NDBBJAFCOBMPICENPHICGEFPCOAA.sanborn@net1plus.com> |
Since I have lots of old and untrustworthy head studs, I just run a coarse thread nut up the bottom of a few studs and thread them into with large washers to hold the liners. Bob Kramer TR4, TR4A, TR6, 2.5 Saloon rgk@flash.net [This message delayed, as it needed manual intervention by the list administrator. mjb.] /// /// triumphs@autox.team.net mailing list /// |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: leaking pinion seal ia.EDU>, erl |
---|---|
Next by Date: | RE: TR-6 Dash Veneer, Bob Danielson |
Previous by Thread: | RE: TR2 crankshaft bearings, cylinder sleeves, etc. (long), Brian Sanborn |
Next by Thread: | Anyone near Santa Maria Calif? x-mac-creator="4D4F5353", bob |
Indexes: | [Date] [Thread] [Top] [All Lists] |