> From: Wages, Jeffrey [mailto:bzw8@cdc.gov]
> Sent: Tuesday, January 30, 2001 2:43 PM
>
> I have an older cast aluminum valve cover for a TR6.
> This cover has counter-bored holes for the mounting
> bolts. I have 2 of the three rubber seals made
> specifically for this counter bored hole. My question
> is does anyone know how/where to get my hands on
> a replacement seal?
Try an MG supplier. I believe MGs (or some of them anyway) used this type of
seal on their valve covers. They also have the special "T" nuts to use which
make the cover look better than with exposed studs and hollow nuts like the
regular setup.
HTH
Peter Zaborski (CF58310 UO)
///
/// triumphs@autox.team.net mailing list
///
|