To: | triumphs@autox.team.net |
---|---|
Subject: | Re: Clutch shaft removal |
From: | RX74EVR@aol.com |
Date: | Sat, 20 Jan 2001 12:51:32 EST |
Ken, You have to drill a hole exactly straight across from the opposite side hole where the taper pin goes in and tap it out from the front side(back out the hole the taper pin went in) with a small punch..While youre at it..Drill the hole larger and through bolt the whole thing for security reasons..Will make it bullet proof..had to do this on my TR6 as i have heard TONS of others do...Good luck! Paul Seedoff 75 TR6 |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Clutch shaft removal, KENNETH WARINGA |
---|---|
Next by Date: | TR6 switch plinth removal, Paul Mitchell |
Previous by Thread: | Clutch shaft removal, KENNETH WARINGA |
Next by Thread: | Re: Clutch shaft removal, Randall Young |
Indexes: | [Date] [Thread] [Top] [All Lists] |