Angelo :
I've had good luck with the model airplane dope in the past. Epoxy (like JB
Weld) should also work well.
Randall
59 TR3A daily driver
On Thursday, November 30, 2000 12:43 PM, Angelo Graham
[SMTP:a3graham@admmail.uwaterloo.ca] wrote:
>
> Hello List:
> Asked a question about the tank sending unit gasket earlier. Another
> question along the same lines.
> Thought I could detect a bit of gas sloshing around my float when I removed
> the sending unit. Any way to seal the float so it doesn't leak? Thought
> about using some model plane "hot fuel proof dope" to seal the seams. Would
> this work or is there some sort of epoxy magic out there for this type of
> application?
>
> Thanks again,
> Angelo Graham
> '55 TR2
|