u should just have to take off the 3 bolts on the inside of windscreen
holding it to dash & the two nuts underneath the dash that holds the two
side pins. mine came straight out; but i had no rust; if you've got rust,
best to load it up with WD40 & wait a day; if u bang on it u might break the
glass. the sid e mounting brackets don't have to be touched.
al salvatore
----- Original Message -----
From: <AndyJS1@aol.com>
To: <triumphs@autox.team.net>
Sent: Sunday, November 05, 2000 6:59 PM
Subject: TR6 Windshield With Frame Removal
>
> Other than a cutting torch, can anyone please share some ideas on how to
> remove the windshield frame from the car? I followed the Bentley manual
and
> it looks like the mounting brackets stay on the car (loosened) and the
frame
> should pull up from them. Probably, but I certainly hope not, the posts
are
> rusted to the brackets. I used a brass headed mallet to try to tap the
posts
> out of the brackets to no visible effect. Also, I ran a putty knife under
> the seal and broke it loose. So, that should not be a problem. Thanks in
> advance.
>
> Andy Schwarz
> Renton, WA
> 70 TR6
> 63 Austin Healey BJ7
|