triumphs
[Top] [All Lists]

Wiring TR3

To: <triumphs@autox.team.net>
Subject: Wiring TR3
From: "James Fowler" <jFowler@mail.southeast.cc.nc.us>
Date: Thu, 24 Aug 2000 08:11:33 -0400
I have almost completed a frame-off restoration of a 1960 TR3A.
That included a new wiring harness (TRF), coil, fuse box, and starter solenoid. 
 I change the positive ground to negative, as described in a VTR section.  I 
have wired all parts of the center dash panel using a wiring diagram as a 
guide.  I have not completed wiring the lights or horns.  Using an ohm meter, 
all of the grounds check out.  Once the battery is connected , I can use the 
solenoid button to turn over the motor.  My problem is that I am not getting 
any current to the panel, the keyed ignition switch, the coil, or the push 
starter.  Could the regulator break that circuit?  Any hints?

60 TR3A  70K series


<Prev in Thread] Current Thread [Next in Thread>