Michael :
No, in fact the bottom section must already be assembled to the rest of
the frame when installing the gasket, as the gasket covers the screws.
When removing the stanchions, take careful note of which screws go
where, they aren't exactly the same length, and wrong installation can
crack the windshield.
Check the archives for advice on how tight to pull the gasket when
installing. The first time I did mine, I pulled it snug (no waves) and
trimmed to length with the result that it shrunk and tore within a few
months. The second time, I stuffed the whole thing into place (lots of
waves), thinking it would shrink to fit. That was over 10 years ago,
and it still doesn't quite fit <g>
Randall
Michael Ferguson wrote:
>
> I've had enough of rain coming under the rubber gasket at the bottom of my
> windscreen when I get caught in the rain. So...I bought a replacement from
> our friends at TRF. Quick question - is it necessary to remove the bottom
> windscreen frame section in order to replace this, or can it be done by
> simply removing the stantions? Any other words of wisdom from those who've
> been there would be appreciated. Thanks, everyone.
>
> Michael Ferguson
> 1959 TR3A TS53990L...O!
|