Very easy job with the right machinery, which I think you do not have. The
old bushes can be drilled out on a lathe or with a drill press, size 23/64,
install the new bush and then it must be reamed out with a .3120 reamer, now
the finish ream must be a .3130, your shafts should now fit if you have
aligned "BOTH" sides up perfectly and drilled the correct depth, but, just a
reminder, it must be perfect on both sides, or you have 2 "junk" carbs.
Advice, send them to Nissonger's for the 90.00 and that includes the shafts.
"FT"
----- Original Message -----
From: <Desenberg1@cs.com>
To: <triumphs@autox.team.net>
Sent: Monday, February 14, 2000 9:03 PM
Subject: TR-6 Carb Throttle Bushing replacement
>
> Hi All,
>
> I am in the process of rebuilding my carbs and need to replace the
> throttle shafts and bushings. I am looking for some ideas on how to
remove
> the existing bushings. Whats the best way? I am thinking about threading
> them with a tap and then screwing in a bolt. I will then attach to a slide
> hammer and see if that will pull them out. Also installing the new ones,
any
> ideas? Do the new bushings need to be reamed?
>
> Just as a side note. I have had my carbs apart quite a few times
before
> but never removed the throttle shafts. Now, I know where the shaft seals
go
> that come with the rebuild kit. Can't see them without removing the
shafts.
>
> Thanks for the help
>
> Mark
> Southern Maine
>
|