I replaced my clutch back in the Spring and found no such thing on the old
sleeve or on the new one. I just lubed the shaft with grease and put it all
together. I also pressed some extra grease into the new TO bearing(as it was
the point of failure in the old system). Its entirely possible that such a
thing existed on the original system but the VB sleeve I got did not have one.
Good Luck!
--
On Tue, 9 Nov 1999 20:02:00 KTRIUMPH wrote:
>
>hello list,
>
>I seem to have a recollection of a thread here some months ago about there
>being a "stud and groove" sort of thing on the TR6 throw out bearing sleeve
>and the front cover tube that it rides on. It seemed the intent was to
>prevent the t/o bearing sleeve from spinning. Does this sound familiar to
>anyone? I am pretty familiar with the TR3-4 arrangement, and there's nothing
>like this on these tranny's that I recall seeing.
>Thanx in advance for any insight you might have.
>
>
>
>Ken Nuelle
>58 TR3A
>62 TR3B
>64 TR4
>and coming soon, 69 TR6
>
|