Gbouff@aol.com wrote:
>
> Hi Listers,
>
> Just spent most of the day reorganizing my garage. It was badly needed, tools
> everywhere and even if found, no room to work.
>
> That was a secondary motive however. In one of my earlier posts, I had
> mentioned that after getting the engine started (after a 25 year slumber) I
> discovered that I would have to rebuild the head. When I bought the car it
> came with LOTS of spares including new exhaust valves still packed in
> pariffin. I new that they were there, somewhere, finding them was the hard
> part. Naturally,I found them in the very last box.
>
> Not only that, I have a spare head devoid of ancillaries, and other than being
> rusty, appears to be in almost new conditon. So at this point I will shortly
> send out both heads and all valves to a rebuilder, and let him choose what is
> best.
>
> Is there a way to add hardened valve seats to a TR3 head? If so, where do I
> find parts?
>
> Also, does someone offer a rebuild kit for a TR3 water pump? The bearings and
> impeller are fine, I only need the seal and a rubber part refered to as the
> "spinner".
> Victoria British shows the seal available. However, neither they nor Moss
> show the spinner available, and being somewhat new, I still haven't been able
> to get a complete TR3 catalog from TRF as I have been told that it is out of
> print.
>
> Well that's it as far as an update.
>
> Gary Bouffard
> TS 58399
Gary, my first reply was returned, so here goes again
Massey Ferguson tractor part # 825-309-M1, yes avail only from M/F
dealer as far as I know, if none are in your area call Smith & Sons in
Warrenton, Va. & they will drop ship to you with a credit card phone # is
540-347-1991, send me your snail mail & I'll send you M/F parts page
complete with a breakdown of all numbers for a W/P.
|