Dee,
Being an Aussie, I might be a bit biased, but I believe PBR produce good
products and have a good name here. I've always used PBR brake and clutch
products without any problems whatsoever.
I've just bought one of their changeover (rebuilt) clutch kits for my 2500TC
and am more than confident it will be OK, and also have just put their new
kits in the clutch master cylinder and slave cylinder.
Of course others may have had different experiences with PBR stuff.
Regards,
Bob Hutton.
----------
From: Dee Jackson[SMTP:dee_jackson@gilbarco.com]
Sent: Tuesday, 12 May 1998 21:41
To: triumphs@autox.team.net
Subject: Aussie Master Cyl. Kit
Folks,
I just received a brake master cylinder rebuild kit that was made by PBR
Automotive in Australia. ISTR the prevailing wisdom some time back was
that the rubber bits from Down Under were less than what one would
expect. Has anyone had any experience with this company, or should I
send the kit back as a matter of course?
Thanks,
D.
'78 Spit FM90204UO
'73 GT6 KF20632U
--
Dee Jackson Ph. 336-547-5007
Gilbarco Inc. Fax 336-547-5234
Greensboro, NC e-mail dee_jackson@gilbarco.com
|